How to Troubleshoot Netgear AC1750 Setup Issues?

How to Troubleshoot Netgear AC1750 Setup Issues?

Various users face issues while trying to install the Netgear AC1750 WiFi router. If you are amongst those users, then don’t worry! Our experts are here to assist you! In this article, we’ve listed down some of the most common issues that you might be experiencing while performing Netgear AC1750 setup. Not just that, but we’ve also discussed the ways through which you can get rid of these issues. So, read on.

Most Common Netgear AC1750 Setup Issues

Mentioned below are the top 3 issues that are reported by Netgear router users:

  1. Netgear AC1750 router not connecting to the existing modem.
  2. not working.
  3. Cannot access the Netgear Genie smart setup wizard.

Now that you are familiar with the most common Netgear AC1750 setup issues, walk through the troubleshooting steps highlighted below to fix them.

Resolved: Netgear AC1750 Setup Issues

Reduce the Distance Between Your Devices
One of the reasons why you aren’t able to connect your Netgear AC1750 router to the existing modem is because the distance between them is too much. Therefore, reduce the distance between your WiFi devices.

Another reason why you are facing issues while trying to connect your devices is because of a worn-out Ethernet cable. To get the issue fixed, it is recommended that you either replace the cable with a new one or connect your devices wirelessly.

Use the Correct Web Address not working is one of the most common issues that users face while performing Netgear AC1750 setup. If you are facing the same issue, then that’s probably because you’ve entered the wrong web address.
Thus, make sure that you enter the correct web address in the address bar of your web browser. If even using the right web address didn’t resolve the not working issue for you, then you should try using the default router IP.

Note: The default IP address of your Netgear WiFi router may vary depending on the model that is being used. So, before you make the mistake of accessing an incorrect IP address, do refer to the user manual. You’ll find every little detail regarding your device in there.

Verify the Netgear Router Login Details
Are you unable to access the Netgear Genie smart setup wizard? Looks like you weren’t being careful while entering the default login details. Therefore, cross-check the default username and password before pressing the Log In button.

In case you are still having a tough time with the same issue, then chances are that your internet connection is the culprit. To get the internet issue fixed, get in touch with your ISP. Confirm whether the issue is from his end or not. If it is, give him some time to fix it.

If you are still facing Netgear AC1750 setup issue , then take the help of the troubleshooting steps mentioned below to rid yourself of it:

Troubleshoot Netgear AC1750 Setup Issues

Power Cycle Your Netgear Router
Sometimes, technical glitches can also make you come across Netgear AC1750 setup issues. To get rid of them, it is advised that you power cycle your WiFi device. To do so, follow the aforementioned steps mentioned below:

  1. Disconnect all the WiFi devices connected to your router.
  2. Power off your router and unplug it from the wall socket.
  3. Wait for some time.
  4. Then, plug your router back into the socket.

The Conclusion

Facing Netgear AC1750 setup issues is quite common, but you can easily fix them with the help of the above-mentioned troubleshooting steps. On the off chance if you still aren’t able to configure your device properly, then reach out to our well-versed experts immediately.

Disclaimer: is completely an autonomous service provider for routers and range extenders along with similar networking devices. All third party trademarks, brand names, products, and services are used only for informational and referential purpose. We hereby disclaim any sponsorship, affiliation, or endorsement of any such third party brand, product, or service. Our services are provided only on request by users.